How does satellite finder use?

Satellite finder how to use is the customer to buy satellite finder often asked the question, the following for everyone to introduce the use of satellite finder steps:

1. Connect the satellite finder side labeled "TO LNB" to the antenna tuner, labeled "TO REC" on the other side and connect the receiver and the TV to the receiver.

2. When the receiver is turned on, the voltage supplied from the receiver is 13-18V. Check whether the satellite finder is on. If the indicator is on, the satellite finder is working normally.

3. Set the data of the satellite to be received in the receiver. (Including the local oscillator frequency, downlink frequency, symbol rate, polarization, etc.) and open to the signal strength, signal quality cursor state.

The above is a brief introduction to the use of satellite finder, learn more about the satellite finder content, please pay attention to kepnixshop official website.