The method of using Satellite Finder

1.open satellite finder

(1) the satellite finder side marked "TOLNB" connected to the antenna tuner, the other side marked "TOREC" connected to the receiver, and the receiver and the TV on.

(2) the receiver opened out by the receiver voltage for the 13-18V, check whether the finder lights, lights said finder is operating normally.

(3) set the data to be received in the receiver. (including the local oscillator frequency, downlink frequency, symbol rate, polarization, etc.) and open to signal strength, signal quality cursor status.

2.The satellite finder instrument panel operation:

(1) satellite finder is the configuration of the helical attenuator attenuation adjustment signal receiver size, power, operational control in the pointer spiral attenuator scale 5 on the grid,satellite finder will emit a faint sound, then shake slightly near the antenna, you need to find the Satellite Finder found a satellite signal input, the noise will be increased, the pointer will also rise to the scale between 8-10 lattices or higher, the satellite signal input. At this point, combined with the receiver's signal quality cursor to see if you are looking for a satellite.

(2) the satellite signal finder can not identify the user need, any satellite signal input, finder all display signal. At this point only from the satellite receiver input to find the satellite signal quality signal to confirm the cursor.

(3) Ku band can be directly connected to the C band adjustment between the star finder to LNB a series power divider or 100 meters of cable, to signal attenuation, otherwise it will cause the self-excited finder can not be reduced.

(4) in tall buildings or between the strong interference zone of star finder will self-excited howling caused not hand down.

3.if the finder received signal and digital signal machine could not show the following situations

(1) is not the satellite signal that the user is looking for.

(2) LNB polarisation.Focus placement error, need to adjust.

(3) weak signalThe device will also decline between the pointer to 4-5 to adjust the antenna tuner or the signal increased again.

(4) the pointer finder refers to the maximum, but no signal.Because the signal received by the Satellite Finder is judging whether a satellite antenna preliminary, but the signal is not needed can be directly displayed in the finder on the dial, it is looking for a kind of auxiliary equipment of the satellite signal.

(5) in the absence of an antenna, the pointer is always at the top.Check whether the front antenna at the building or front is blocked, if these phenomena do not exist, indicating that the LNB gain is too large, the lost signal attenuation part finder.

The above is the brief introduction to the method of using Satellite Finder, more about the satellite finder content, please pay attention to the official website of kepnixshop.